Rotating Cross Cutter Firmware CT803

•The Motrona MC800 multi-axis motion controller, a successor to the proven MC700, has an even higher bandwidth and with a more flexible bus architecture.
•The universal encoder inputs allow the connection of various encoders and other sensor systems.
•The integrated tandem drive controller is a special feature of this system, which enables the acceleration demand of following axis to be achieved by distributing power on two independent drives.
•2 pulse inputs with format A, /A, B, /B, Z, /Z [HTL, RS422] with an input frequency up to 2 MHz
•2 control inputs with format SIN+, SIN-, COS+, COS- [1 Vss] with an input frequency up to 400 kHz
•2 SSI inputs with format DATA+, DATA-, CLOCK+, CLOCK- up to 25 Bit, with SSI switching frequency of 100 Hz ... 1 MHz
•2 scalable 14 bit analog inputs for ±10 V or 0/4 ... 20 mA
•4 control inputs for PNP / NPN signals [10 ... 30 VDC]
•4 fast interrupt inputs for PNP / NPN signals [10 ... 30 VDC]
•1 pulse output with format A, /A, B, /B, Z, /Z [RS422]
•4 control outputs with push-pull characteristic, short-circuit-proof [5 ... 30 VDC]
•2 scalable 14 bit analog outputs for ±10 V or 0/4 ... 20 mA
•Loop time approx. 250 µs
•Power supply 18 ... 35 VDC
•Snap-on housing for top hat rail (according to EN 60715)
•OnBoard interfaces: Ethernet / IP, RS232 / RS485, USB 2.0, CANopen, Modbus RTU
•Optional Ethernet interfaces: EtherCAT, Ethernet / IP, Modbus TCP, Powerlink, PROFINET, SERCOS III
•Optional Fieldbus interfaces (slave): CC-Link, DeviceNet, PROFIBUS
•Operates with all 4-Q-drive systems, equipped with a standardized drive communication bus (e. g. SERCOS-II). Alternatively ±10 V setpoint can be used
•The controllers can be setup by an external operator terminal as well as HMI’s via standardized factory communication bus e. g. PROFINET
•Setup via windows operator software