Currency
Flying Material Processing Firmware FS801
Availability:
In stock
SKU
FS801
Vendor : Stock Electronics
Manufacture
Motrona
- By using the FS801 firmware, the MC800 controller is equipped for motion control tasks with typical “on-the-fly-processing” machines for example sawing, cutting, punching and drilling.
- 2 pulse inputs with format A, /A, B, /B, Z, /Z [HTL, RS422]
- With an input frequency up to 2 MHz 2 control inputs with format SIN+, SIN-, COS+, COS- [1 Vss]
•With an input frequency up to 400 kHz 2 SSI inputs with format DATA+, DATA-, CLOCK+, CLOCK- up to 25 Bit, with SSI switching frequency of 100 Hz ... 1 MHz 2 scalable 14 bit analog inputs for ±10 V or 0/4 ... 20 mA 4 control inputs for PNP / NPN signals [10 ... 30 VDC] 4 fast interrupt inputs for PNP / NPN signals [10 ... 30 VDC] 1 pulse output with format A, /A, B, /B, Z, /Z [RS422] 4 control outputs with push-pull characteristic, short-circuit-proof [5 ... 30 VDC] 2 scalable 14 bit analog outputs for ±10 V or 0/4 ... 20 mA Loop time approx.
•250 µs Power supply 18 ... 35 VDC Snap-on housing for top hat rail (according to EN 60715)
•OnBoard interfaces: Ethernet / IP, RS232 / RS485, USB 2.0, CANopen, Modbus RTU
•Optional Ethernet interfaces: EtherCAT, Ethernet / IP, Modbus TCP, Powerlink, PROFINET, SERCOS III
•Optional Fieldbus interfaces (slave): CC-Link, DeviceNet, PROFIBUS Operates with all 4-Q-drive systems, equipped with a standardized drive communication bus (e. g. SERCOS-II).
•Alternatively ±10 V setpoint can be used The controllers can be setup by an external operator terminal as well as HMI’s via standardized factory communication bus e. g. PROFINET Setup via windows operator software
| Manufacturer | Motrona |
|---|
Write Your Own Review